Allpowers solar charge controller comes with a display that can clearly indicate the status and data, it can be conveniently switched modes and parameter configuration, suitable for home, industrial, commercial, etc.
They were equipped with an industrial-grade STM 8 microprocessor to control the charger and discharge process and it has a reliable battery to charge and discharge period management
*Voltage: DC 12V/24V
*Rated Charge Current: 20A
*Rated Load Current: 20A
*Over charge Protection: 14.4V/28.8V
*Over charge Floating charge: 13.7V/27.4V
*Charge recover voltage: 12.6V/25.2V
*Over discharge Protection: 10.7V/21.4V
*Over discharge Recover: 12.6V/25.2V
*USB output: 5V/3A
*Operating temperature: -35℃-60℃
*Size:150 * 78 * 35mm / 5.9 * 3 * 1.4in
Q: How to install it?
A: (1)Battery --->(2)Solar panels ---> (3)DC load
Q: Why does the LCD screen become blank?
A: When the battery voltage is too low, the controller will stop to output(≦ 8V, controller turns itself off, LCD is blank, ≦ 10.7V, 12V output ports are not available); after the solar panels charge, it will re-output when the battery will return to 12.6V.
Q: What battery type is this controller supported?
A:B01= OPEN B02= AGM B03= GEL. The regulator is only suitable for lead-acid batteries, not for nickel hydride, lithium, ions, or other batteries. Let the children keep far away from the storage battery and the controller.
<1> Wire Range: 26-12 AWG
<2> Make sure the voltage of your battery reaches 11V for initial use, so as to start up for the controller to registered the battery type accordingly.
<3> Old batteries may be degraded capacity after hundreds of cycles, easily dropping lower than 8V, which results in the controller will be shut off (LCD screen becoming totally “DEAD”).
<4> Indoor use only: the working temperature of this controller is -35°C to +60°C. During hot sunny days, the temperature outside might go up to 60-75°C. Please do keep the controller stay in a cool and well-ventilated place to maintain good heat dissipation